|
     
After going to the track with
this setup I was able to do 4 15.2 runs back to back. Usually I would
run a 15.2 then 15.4 then 15.6 then 15.8 if I ran them back to back. I
also picked up 2 mph in the 1/4 mile
Parts required besides the
sheet metal shroud.
1 - Corvette Duct Assembly GM Part # 25147192
1 - MAF Harness Extension GM Part # 12529241
1 - 6" S&B Powerstack Filter Chrome w/3.5" Flange,
Clear Image Automotive Part # R-35-006 $48.00
1 - # 060 108MM Stainless Clamp
Here's an
excellent tech
article on everything but the sheet metal portion. Remember to
install your MAF with the connector side towards the hood if you plan
on installing the sheet metal later
Installed! Makes car much more
consistent and 2mph in the 1/4!
|
